15 inch (381mm) / 17 inch (432mm) corded mower
instruCtion manual
date code:
catalog number
em1500, em1700
EM1500
EM1700
key information you should know:
• Do not operate mower unless handle is locked into position.
• For best cutting results, keep blade sharpened and balanced.
• Inspect and thoroughly clean your mower after each use (a deck with caked grass will degrade performance).
• Make sure mowing area is clear of other persons or pets prior to starting and during operation.
Thank you for choosing black & decker!
Go to www.blackanddecker.com/newowner to register your new product.
Please read Before returning this ProduCt for any reason:
If you have a question or experience a problem with your Black & Decker purchase, go to
hTTp://www.blAckAnddecker.com/insTAnTAnswers
for instant answers 24 hours a day. If you can’t find the answer or do not have access to the internet, call 1-800-544-6986
from 8 a.m. to 5 p.m. EST Mon. - Fri. to speak with an agent. Please have the catalog number available when you call.
Vea el esPanol en la ContraPortada.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE GARANTÍA. AdVerTenciA: LÉASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
saVe this instruCtion manual for future referenCe.
Download from Www.Somanuals.com. All Manuals Search And Download.
when necessary replace with Black & Decker recommended parts only.
9. Mower blades are sharp. Wrap the blade or wear gloves, and use
extra caution when servicing them.
minimum Gauge for cord sets
Total length of cord in feet
26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50 51-100 101-200 201-300
Volts
120V
0-25
10. Maintain or replace safety and instruction labels, as necessary.
240V
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
noTe: This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere rating
More
Than
0
6
10
Not more American Wire Gauge
Than
6
10
12
16
-
-
-
-
18
18
16
14
16
16
16
12
16
14
14
14
12
12
12
Not Recommended
A
A1
Appliance
cord
Cord set
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and the receiver.
. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This Class B digital apparatus complies with Canadian ICES-003.
Tie cord as shown
Connect plug and receptacle
• Don’t Abuse Cord – Never pull lawn mower by cord or yank it to
disconnect from receptacle. Keep cord from heat, oil, and sharp edges.
• Don’t Force Lawn Mower – It will do the job better and safer at the
rate for which it was designed.
FOR ALL DOUBLE-INSULATED LAWN MOWERS
1. Replacement Parts
When servicing use only identical replacement parts.
2. Polarized Appliance Connections
• Don’t Overreach – Keep proper footing and balance at all times.
• Stay Alert – Watch what you are doing. Use common sense. Do not
operate lawn mower when you are tired.
To reduce the risk of electric shock, this appliance has a polarized plug
(one blade is wider than the other) and will require the use of a polarized
extension cord. The appliance plug will fit into a polarized extension cord
only one way. If the plug does not fit fully into the extension cord, reverse
the plug. If the plug still does not fit, obtain a correct polarized extension
cord. A polarized extension cord will require the use of a polarized wall
outlet. This plug will fit into the polarized wall outlet only one way. If the
plug does not fit fully into the wall outlet, reverse the plug. If the plug
still does not fit, contact a qualified electrician to install the proper wall
outlet. Do not change the equipment plug, extension cord receptacle, or
extension cord plug in any way.
• Disconnect Lawn Mower – Disconnect the lawn mower from the
power supply when not in use, before servicing, when changing
accessories such as blades, and the like.
• Store Idle Lawn Mower Indoors – When not in use, lawn mower should
be stored in an indoor dry and locked-up place – out of reach of children.
• Maintain Lawn Mower With Care – Keep cutting edges sharp and
clean for best and safest performance.
Follow instructions for lubricating and changing accessories.
Inspect lawn mower cord periodically and if damaged, have it repaired
by an authorized service facility. Inspect extension cords periodically and
replace if damaged. Keep handles dry, clean, and free from oil and grease.
• Keep guards in place and in working order.
wArninG: GenerAl sAfeTy wArninGs And
insTrucTions for All mowers
• This Tool cAn be dAnGerous. Follow all warnings and Safety
Instructions in this manual. The operator is responsible for following
warnings and instructions in this manual and on unit. Restrict use of
this mower to persons who read, understand and follow warnings and
instructions in this manual and on unit.
• Keep blades sharp.
• Keep hands and feet away from cutting area.
• Objects struck by the lawn mower blade can cause severe injuries
to persons. The lawn should always be carefully examined and
cleared of all objects prior to each mowing.
• Avoid Dangerous Environment – Don’t use lawn mowers in damp or
wet locations.
• If lawn mower strikes a foreign object, follow these steps:
• Stop lawn mower. Release the switch
• Don’t Use In Rain.
• Unplug power cord.
• Inspect for damage.
• Keep Children Away – All visitors should be kept a safe distance from
work area.
• Repair any damage before restarting and operating the lawn mower.
• Use identical replacement blades only
• Dress Properly – Do not wear loose clothing or jewelry. They can
be caught in moving parts. Use of rubber gloves and footwear is
recommended when working outdoors.
sAVe These insTrucTions
• Use Safety Glasses – Always use face or dust mask if operation is dusty.
• Use Right Appliance – Do not use lawn mower for any job except that
for which it is intended.
dAnGer: AddiTionAl wArninGs for mowers
• check for dAmAGed pArTs. Before further use of the mower,
a guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that may
affect their operation. A guard or other part that is damaged should be
properly repaired or replaced by an authorized service center unless
otherwise indicated elsewhere in this manual.
• repAirs And serVice. Repairs, maintenance and any adjustments
not specified in this manual should be performed by Black & Decker
authorized service centers or other qualified service organizations,
always using identical replacement parts.
• Ground Fault Circuit Interrupter (GFCI) protection should be
provided on the circuit(s) or outlet(s) to be used for the lawn mower.
Receptacles are available having built-in GFCI protection and may be
used for this measure of safety.
•
wArninG: To prevent electric shock use only with an extension
cord suitable for outdoor use, such as SW, SOW, STW, STOW, SJW,
SJOW, SJTW, or SJTOW.
• use of exTension cords
Make sure the extension cord is in good condition before using. Always
use the proper size extension cords with the tool – that is, proper wire
size for various lengths of cord and heavy enough to carry the current
the tool will draw. Use of an undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. For proper size cords
see chart below. To reduce the likelihood of disconnection of lawn
mower cord from the cord set during operating:
wArninG: Some dust created by this product contains chemi-
cals known to the State of California to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• compounds in fertilizers
i) Make a knot as shown in Figures A and A1, or
ii) Use one of the plug-receptacle retaining straps or connectors
described in this manual.
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter out
microscopic particles.
Download from Www.Somanuals.com. All Manuals Search And Download.
3
FUNCTIONAL DESCRIPTION (FIG. B)
SECURING ThE MOTOR CABLE (FIG. F)
1.) Switch box
2.) Bail Handle (EM1700), Switch lever (EM1500) The motor cable has to be fixed using the cable restraints.
3.) Handle knobs
5.) Cable holders
7.) EdgeMax™
9.) Compact lever
11.) Clear rear flap
4.) Cable management system
6.) Height adjustment lever (not shown)
8.) Grass collection box
• To clip the cable to the handle, snap a restraint clip (10) around the cable
and upper handle about 6 inches (152.4mm) below the switch box (1).
• Snap the second restraint clip around the cable and lower handle
about 6 inches (152.4mm) below the handle knob (3).
10.) Carrying handles
FITTING ThE GRASS COLLECTION BOx (FIG. G)
• Lift the clear grass flap (11) and place the grass collection box (8) over
the lugs.
EM1500
B
2
D
E
2
4
3
1
5
8
6
F
G
11
10
9
10
6 inches
(152.4 mm)
11
6 inches
(152.4 mm)
7
ASSEMBLy
operATion
reAd This insTrucTion mAnuAl And sAfeTy rules before
operATinG your mower. See “functional description” to famil-
iarize yourself with the location of various controls and adjustments.
Save this manual for future reference.
wArninG: Before assembly, make sure that the appliance is
switched off and unplugged.
ASSEMBLING ThE GRASS COLLECTION BOx (FIG. C)
wArninG: roTATinG blAdes cAn cAuse serious
injury. To preVenT serious injury, unpluG mower when
unATTended, cleAninG, serVicinG, TrAnsporTinG, lifTinG,
or sTorinG mower.
wArninG: sharp moving blade. Do not operate the mower if
the rear door is not closed under spring tension as serious injury could
result. Take your mower to the nearest service center for repair.
wArninG: sharp moving blade. Never operate the mower
unless the hanger hooks on the grass catcher are seated properly on
the mower and the rear discharge door rests firmly against the top of the
grass catcher as serious injury could result.
wArninG: Under normal usage,
the collection box assembly is subject
8a
C
to deterioration and wear and should,
therefore, be frequently checked for
replacement. Any replacement
assembly should be checked for
compliance with Black and Decker
recommendations.
8b
8c
The grass box (8) requires assembly
before use and comes in 5 pieces.
• Clip the handle (8a) into the lid (8b)
of the grass box. The handle will only
fit one way.
wArninG: Do not operate mower without collection box (8) attached.
wArninG: Let the appliance work at its own pace. Do not overload.
• Clip the 2 sides (8c) of the grass
collection box together. Make sure
that all clips and guides are aligned.
• Align the assembled sides onto the
bottom (8d) of the grass collection box.
Ensure that the 4 guides are aligned.
• Push the 2 parts together. Apply
even force around all edges of the
grass collection box securing the
clips into position uniformly. Check
ADjUSTING ThE hEIGhT OF CUT (FIG. h)
The height of cut is adjusted by the central height adjust mechanism,
there are 6 positions to choose from.
To set the height of cut
• Pull the height adjustment lever (6) away from the body of the unit.
• Move the lever towards the rear of the appliance to lower the height of cut.
• Move the lever towards the front of the appliance to raise the height of cut.
• Push the height adjustment lever into one of the 6 height locations.
NOTE: The height of cut can be viewed on the height of cut gauge (12)
on the side of the unit.
8d
that each clip is fastened together securely.
• Align the lid (8b) onto the assembled grass collection box. Ensure that
the 10 guides are aligned.
NOTE: Take extra care when aligning the 2 clips at the rear of the grass
collection box.
EM1500
h
6
I
• Push down on the lid to secure all clips. Begin at the back and ensure
that all clips are securely located.
FITTING ThE LOWER hANDLE (FIG. D)
• Insert the ends of the lower handle into the corresponding holes in the mower.
• Press the handle down as far as it will go.
13
• Secure the handle using the screws.
ASSEMBLING ThE UPPER hANDLE (FIG. E)
• Fit the upper handle part to the lower handle using the handle storage
knobs (3), washers and screws as shown.
12
1”
3” 2”
EM1700
Download from Www.Somanuals.com. All Manuals Search And Download.
4
|